Aquacal AT100 Instalační manuál

Soft Water Purification System CUBBY by AquaCal AutoPilot INC. Residential Operation / Installation Manual Chlorine Jerry

- 9 - Section 2d – INSTALLATION Locating and Installing the Cell The Location of the Control Panel is not drawn to scale and cannot be mounted clos

- 10 - Section 2d – INSTALLATION Locating and Installing the Cell (Continued) Convection Cell Installation Diagrams In-Deck Canister with Cell: Us

- 11 - Section 3a – OPERATION Key Features and Controls Key Features Your Cubby is equipped with several key features and very few controls to make

- 12 - Section 3b – OPERATION Understanding System Sizing Cubby Purifier Demands The rate at which Purifier is consumed in any swimming pool depe

- 13 - Section 3c – OPERATION Start Up Procedures The following steps should be taken to ensure a proper start-up with the Cubby Purifier. In the

- 14 - Section 3d – OPERATION Pool Water Preparation Salt Requirements A salt residual of 2500 to 3500 ppm should be maintained at all times for pe

- 15 - Section 3e – OPERATION Monitoring and Maintenance Water Chemistry - VERY IMPORTANT NOTE! Your Cubby is designed to provide Purifier on a da

- 16 - Section 4a – TROUBLSHOOTING AND SERVICING TROUBLESHOOTING PROBLEM CAUSE SOLUTION 1) Insufficient Purifier Production A) The test kit reag

- 17 - Section 4b – TROUBLSHOOTING AND SERVICING SERVICING AND REPLACING PARTS Replacing the Control Panel Turn off all power going to the Cont

- 18 - Section 4b – TROUBLSHOOTING AND SERVICING SERVICING AND REPLACING PARTS (Continued) Accessing the Cell Body The In-Line Cell Body and Flo

- 1 - Section 1a – GENERAL PRODUCT INFORMATION POOL PILOT CUBBY by AquaCal AutoPilot INC. Record Following Information & Provide When Calling F

- 19 - the same location as the original Cell and cord. Re-assemble the Plug-N-Play Cell Body and Canister, and then screw on the Top Float. Take c

- 2 - Section 1b – GENERAL PRODUCT INFORMATION IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS INSTALLATION AND EQUIPMENT RELATED

- 3 - Section 1c – GENERAL PRODUCT INFORMATION Table of Contents CUBBY by AQUACAL AUTOPILOT INC. Section 1 GENERAL PRODUCT INFORMATION 1a P

- 4 - Section 1d – GENERAL PRODUCT INFORMATION Technical Specifications CONTROL PANEL CHLORINE CELL MODELS 400-3, 400-5, & RC-5 Power In: 10

- 5 - Section 2a – INSTALLATION Material Requirements for Installation NEEDED BY INSTALLER SUPPLIED WITH POOL PILOT 1) Required Amount of Salt

- 6 - Section 2b – INSTALLATION Locating and Mounting the Control Panel Control Panel WARNING: USE THE SUPPLIED ANCHORS AND SCREWS TO MOUNT THE CO

- 7 - Section 2c – INSTALLATION Control Panel Connections Electrical Connections: In-Line units must be integrated with the Pool Pump Operation and

- 8 - Section 2c – INSTALLATION Control Panel Wiring European 220 Volt / 50 Cycle Models Only The 220V Cubby models come supplied with 2 m (6.7